How to load existing game map into Unified Editor

[blueferret]

Get a huge amount of errors when doing so. Used space.bin-util to extract the space. The map is sand river and i think it's just an issue of copying over all the resources stored inside of the shared .pkg files, but those are almost 1gb each.

[SkepticalFox]

Yes, you need to extract all required resources that map needs.

 

[blueferret]

Thought so. Thanks

[blueferret]

On 4/25/2020 at 1:37 AM, SkepticalFox said:

Yes, you need to extract all required resources that map needs.

 

Done this, and the map loads, except 75% of the map's terrain doesn't load, whereas 25% of it loads fine. Screenshot below; also cannot save the map without UE just crashing :/

24 minutes ago, blueferret said:

Done this, and the map loads, except 75% of the map's terrain doesn't load, whereas 25% of it loads fine. Screenshot below; also cannot save the map without UE just crashing :/

 

It complains about the atlases, can't figure out why.

[blueferret]

bump

[blueferret]

@SkepticalFox any thoughts on this?

On 5/26/2020 at 10:38 PM, blueferret said:

Done this, and the map loads, except 75% of the map's terrain doesn't load, whereas 25% of it loads fine. Screenshot below; also cannot save the map without UE just crashing :/

 

It complains about the atlases, can't figure out why.

 

[bobo_24_7]

Hello, i am trying do the same thing, but without any reasonable  result. Just wanted to ask, if you somehow figured it out. Thank you.